Pay Pal Credited 2

Engine Mount Kit V2, Billet & CG Position Changeable Silver

$149.65

Arrow Shark 2015 Easy Release Billet Engine Mount Kit V2
Exclusively Featuring Easy CG Position Adjustment
What do you do after you have set up your boat and then, frustratingly, you find the Centre of Gravity (CG, or the balance point of your boat) is either too far forward or too far aft? Or maybe you upgrade to a more powerful engine and find your boat then runs too loose with the bow too high and the hull porpoising.
To correct these situations you need to move your engine, and that is usually a time-consuming, even difficult, task of drilling new mount holes in the stringers (with the old holes looking ugly), or even having to fit new stringers.
Now though, Arrow Shark makes it easy to adjust the balance of your boat with their new billet engine mount kit that includes adjustable rails. Five pairs of mounting bolt holes in the rails enable you to initially install the engine on the centre set of holes, and then easily move it forwards or back until your CG is just perfect.
If your boat is running loose, just move the engine forward; if it is running wet, move it back by one or two holes. Simply un-screw the four mount bolts and slide your engine forward or backward to its next position. The bolt hole spacing allows you to move your engine 30mm at first, and then another 10mm if required for precise adjustment of your boat is balance. Never has engine positioning been so easy, although please note that you will need to change the length of your flex drive shaft and adjust your throttle linkage to suit the final engine position.
This new Arrow Shark billet mount kit offers three colours: Brilliant Red, Jet black, and Silver to match their latest exclusive design CNC rotated carburettor block and short version air venturi to make your engine look as good as it performs. The rotated carburettor block positions the carburettor needle setting screws for easier access, and also gives a more direct and easier alignment for the pushrod to your throttle servo, eliminating the need for bellcranks, cables or other more complicated linkages. The kit comes complete with four rubber mounts, washers and all installation bolts.
The new billet mount V2 kit will work directly with Arrow Shark 254M, Zenoah 260 or 290 Marine engine, RCMK, Tiger King or clone Zenoah style marine engines.Mount2Mount4Mount5


Add to Cart:

  • Model: ASE0003S
  • Shipping Weight: 0.42kilos


This product was added to our catalog on Thursday 19 July, 2018.

Your IP Address is: 54.198.52.82
Pay Pal Credited
Copyright © 2018 Radio Control Hobby Supplies. Powered by Zen Cart